Posted by big jt on June 01, 2008 at 22:56:49 from (206.72.54.246):
In Reply to: Hourly Wage posted by Minn. Norske on June 01, 2008 at 19:06:03:
I have done both of the above. Only did one complete tractor and felt I lost my shirt on it. Was a 9N Didn't appear to need much on the outside but wound up rebuilding the engine, Trans, and replacing all the sheet metal except the hood. I feel I am fussy and don't want to have to go back and fix something after the paint is applied. I also use Acrylic Urethane paints. Wound up the total bill was right at $6000 and only $1000 of that labor. I had Way more hours in it than that though.
As to the tractor driving/farm labor I help a neighbor cut silage in the fall. Started at $10 with this guy bout 10 years ago and last fall he paid $16.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.