Posted by C-man on May 28, 2008 at 17:33:45 from (208.34.15.210):
Thanks to all the guys that responded to my post yesterday in regards to the 1680 combine engine "replace" question. I still don't know what I'm going to do. We replaced the turbo a couple years ago and that did not help the oil consumption problem. It has been using oil for about 3 years. The MAJOR oil leak started to get bad the last week of harvest last fall. I'm sure it is the rear main seal. Talking to several CIH mechanics, replacing the seal along with the other things(the oil pan gasket and I'm not sure what else the said to do)that SHOULD be replaced when doing the seal would be a pretty major job. Would have to raise the motor up to get the pan off and replace the gasket correctly. As I understand it, some of the first engines that came out in the combines had "soft" sleeves. These were supposed to be fixed, but I bought this machine used with 800 hrs, so I don't know if they were replaced. We have serviced the engine religiously and used the CIH oil and filters, so it is not from lack of service or inferior products. The combine is in pretty fair shape for the amount of hours it has on it. We try to keep things replaced that need to be replaced. Finding a "parts machine" with a good engine would be at least $15000-$25000 around here. Unfortunatly replacement of the entire combine is not finanacialy(sp?) possible. Although most people think us farmers are having "record" profits with the high grain prices. The salvage yard said they have a 1 year warranty on the used engine, so that might make the decision easier to go with the used. Have to think about it for a while.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers WD45 (Gas Version) - by Staff. Beginning production in 1953, the WD45 had the same general look as the WD tractor which was produced earlier - but was much more powerful. This was due to the new 4-cylinder "Power Crater" gasoline engine with a 4 x 4-1/2 inch bore and stroke. Some people feel this was one of the most significant tractors offered by Allis-Chalmers in those days. Nothing in its weight or power class could match its performance. In 1954 they began offering the WD45 with the new "Snap-Coupler&quo
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
