Posted by James22 on May 28, 2008 at 13:39:44 from (207.179.239.62):
In Reply to: Re: DR equipment posted by Bill46 on May 28, 2008 at 11:46:05:
A IH350D is way to much tractor for a DR. You sound like a good old boy that buys something and intends to use it. Look for something built better that is used. If located near Central Illinois we have been wanting to upgrade to power feed and would sell ours. Rated for 5 inch limbs, it will handle anything you can suffer to force thru it. With two of us pushing we have chipped a limited amount of 3 inch hedge. I've seen several slightly used non-power feed chippers at dealers. Many purchase a non-power feed chipper thinking it will be a piece-of-cake and find out you need to be built like Paul Bunyan to feed in larger limbs. Consequently it comes back to the dealer, whom offers it at a decent discount. Suggest you look locally for a sturdy built bargin.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - It Can't Be Done! - A Tractor Story - by Neil Campbell. I'll never forget the time back when I was a boy baling hay on our Farm in Big Rapid, Michigan. The most memorable event that took place was a trip up the steepest incline on the farm pulling an old New-Idea baler with a pony-motor for power and a haywagon. I had just talked my Dad into buying an old John Deere B with 6-speeds ahead and I was real proud of it, except it was a little smaller than the Case tractor that we normally
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
