Posted by jdemaris on May 20, 2008 at 06:19:42 from (67.142.130.39):
In Reply to: shaw do-all mod r6 posted by case441 on May 20, 2008 at 05:37:15:
I'd pay $500 without giving it much thought. But, I'm too cheap to pay any more for it. It has individual wheel brakes, a full synchronized Warner transmission, etc.
Past couple of years there has been increased interest in Shaws - mostly the four wheeled tractors. There is a big Shaw tractor show/meet every year in Galesburg, KS where they were built. I've been collecting them for 30 years and bought many for $50 - $100. Past few years - I've seen many like you describe sell for $500, $1000, and sometimes more. The R12s with the twin-cylinder Wisconins sometimes go even higher. I'm too cheap to spend big money for them and don't buy much anymore. If you don't want it - and it's anywhere near New York - let me know and I'll buy it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.