Posted by ChadS on May 13, 2008 at 05:16:17 from (4.224.78.206):
In Reply to: E85 in supper C IH posted by Alan Harmon on May 12, 2008 at 19:35:40:
Your looking at rejetting the main circuit of the carburator. Drilling the main jet a few sizes larger. But first, you need to know how much cyl pressure your engine has to know how much E85 you can run. The higher cyl pressure the better, or more E85 you can run. If the Super C tests 150 psi, you can run safely a 75% gas- 25% E85 mix and see a difference. If it tests 170 and above, you can run a 50-50 mix,, up to 300 psi of cyl pressure. Currently, im setting up a H for pulling, and Ive ran it for a long time on E85,,, even left some in the tank to see what happens,,, it does spoil if not kept fresh,,, but it breaks down into an oily substance, like a thick corn oil residue. My cork seal in the sediment bowl was ok as long as it was running, but let it sit over time, it deteriorates, but its not a big deal, they need replaced every so often anyways. Hope this helps, ChadS
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.