Posted by mEl on May 11, 2008 at 17:10:11 from (75.104.128.57):
In Reply to: battery charging posted by StuBC on May 11, 2008 at 16:16:46:
To properly charge the battery you should have a hydrometer to test the specific gravity of the electrolyte. Remove the caps and observe the activity in each cell, they all should be gassing evenly and not to hard, It is better to slowly charge the battery than to quick charge it. If one cell is gassing badly and the others are not, the gassing cell is most likely bad. If a cell gasses badly when the starter is engaged and the engine does not turn normally, the cell that gasses is bad. The normal specific gravity of a charged cell will be at 12.60, lower but even means the battery is discharged. badly uneven readings indicate weak or bad cells. As the other posts have said, use eye protection and unplug the charger before removing charger connections. There is much more science to batteries and charging but this will get you off on the right foot.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
