Saw those machines once, sort of kinda like a little bit like the huge Claas forage harvesters. Something to see. I will guess the leaves are higher than average sugar content, and could be collected for processing.
'Here' sugar beets are pretty common not far from me, wonder if they will get on board with fuel processing.
Think the waste parts would be difficult to store, and ethanol plants are more efficient if they run 24/7/365. Some of these input crops are pretty seasonal and difficult to store. Makes using them look better on paper than in real life.
Hope they get more of this stuff figured out sooner, I'm all for it.
Looks like a lot of the corn ethanol plants are looking into combining, using corn cobs or switch grass as well as corn. This allows multiple inputs, instead of relying on just corn. And the mess left from processing corncobs or switchgrass can be burned for heat or electricity. As well some are starting to press the oil out of the corn, and make bio-diesel from the small amount of oil in the corn crop. Every little bit....
Will take time to sort out what works and what doesn't.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.