You apperantly haven't spent much time operating tractors that dance on two wheels. I've done a lot of it. Some by necessity and some for the sake of it. I mostly learned to drive by hauling 1000-1200# round bales on a spike hitched to a Ford 860. Many a trip was made in reverse up a hill and many more were headed down hill with the front wheels in the air, steering on the brakes. The worst thing that was going to happen is that the bale would hit the ground, bounce and the tractor would settle down... or if it was a real heavy one I'd have to let the bale down, back up and spin around again. I did hundreds of hours of that. There are very few situations where the tractor will pass it's balance point on the rear axle before a three point load touches the ground, so I don't expect that the linkage would need to support the weight of the tractor. You are no doubt correct that some would fold up quite easily under that kind of weight if they were placed in a situation where the weight of the tractor was placed upon them. Most that I deal with would not. That would depend entirely on the tractor.
ROPS will not prevent a tractor from flipping over. They will probably prevent someone from being killed if they do flip it over provided that they're wearing a seat belt.
Tractors are only lumps of iron. They can be controlled. There's more value in learning about what they can do rather than worrying about every stupid little thing that could happen. Popping a wheelie on an old tractor is not something to stain your pants over. It's pretty normal, really.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Gettin My Old Tractor Home - by Clayton Sweeney. My name is Clayton Sweeney. I am from Southern Maryland in a small town called Lothian. I am 20 and my father and I are the proud owner of a 1954 Allis Chalmers WD-45. When I was 18, I dated a girl in the next county over. Her family are tobacco farmers. It was a cold Thanksgiving evening, and we were going up to her Grandparents house. As we passed one of their barns, I noticed something orange in the corner of my eye in this old shed. It was pretty dark and I asked what it was
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
