Hello Guys; The bulding is 40ft wide. The lower part of the poles is treated. There is a hole drilled though the post at 8" from the bottom. Then a 16" long rebar is put in the hole. The poles are 8ft down, with a concrete pad 10" thick. Then 2 bags of mud are put at the bottom. Then there is 1" styrfoam on all four sides of the post. I will lay 2" pink all around the shed,and back fill on top. Also,4x8 sheets across the doorways. We have deep frost and 40 to 60 below temps, so you get to spend a LOT of cash, were no one sees it!! There are sheds all over with 1 or 2 or6 poles coming up. Frost does NOT push from the bottom of a post,,,,it grabs around and lifts...then dirt falls in at thaw time and shed stays up.Bobmn and the straw or chips sounds good
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Case VA Series - by Staff. V, VC, VI and VO). Althouh the Case VA looked much like the V, it shared no major components with its predecessor. Except for military units, the production of the Case VA was interrupted in July of 1942 due to World War II. It resumed again in 1944 and continued until 1953. It started up briefly later on in 1953 and continued on a very limited basis until 1956. The VA Series included the following models: VA: Fixed front wheel tread VAC:
... [Read Article]
Latest Ad:
Massey Ferguson model 65 diesel tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
