|
Tractor Talk Discussion Board |
Re: cub- know just enough to be dangerous
[ View Follow Ups ] [ Post Followup ] [ Return to Tractor Talk Discussion Board ]
Posted by Mitch on January 18, 2000 at 19:05:32 from (204.94.43.158):
In Reply to: cub- know just enough to be dangerous posted by john on January 18, 2000 at 12:20:54:
Not wise to put new pistons in a old hole. Pistons will "wear into" a bore and adding new ones into a honed bore will end up with less than a satisfactory outcome. Everything depends on the specs and how much wear was in the old holes. Honing is suppose to produce a scratched crosshatch finish as this alows the new rings to seat so this alone doesn't mean much. How much are you going to use the tractor and how hard are you going to push it? Longevity will come with new pistons and a new bore. A weekend tractor will most likely be fine with a hone and re-ring using the old pistons if everything is within perameters for wear
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
It's Alright Where It Is! - by Anthony West. I have a tale of a different kind to tell. Whilst rooting in the hedge bottoms this week I had cause to visit Chapel lane Farm, the home of an eccentric gentleman by the name of Austin Kendall. I had heard rumours that an old Case Model C was languishing away in the back of one of the outbuildings there. So off I went in search of what would turn out to be a very rare and unusual tractor. Mr Kendall is an excitable chap to say the least. He is amongst the last of a dying breed of farmer who
... [Read Article]
Latest Ad:
Wanted to buy model 65 massey ferguson 65 diesel
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
