Posted by RodInNS on April 20, 2008 at 16:00:46 from (24.224.246.156):
In Reply to: Logging Skidder posted by fergienewbee on April 19, 2008 at 14:51:49:
What kind of mess are you talking about? Do you not like clear cuts that leave a pile of slash on the ground, or do you not like the ruts associated with narrow tires, skidders and repeatedly using the same trails? If you're bothered by the former and you prefer a selective cut then a skidder is about the only sensible way to go. Drag the wood out tree length to a landing and load it there. If you're working with Veneer or even high grade saw logs then it will pay you to have somebody knowledgeable cut that stuff to length. If you only have a small amount of the stuff then you'll probably waste your best wood on YOUR education. If you're going to do a lot of this then it's worth your time to learn.... but just be aware of that fact. That's one game that has a very steep learning curve and the line that separates firewood from veneer is only inches....
If you're bothered by the ruts and associated mud and mess then go with a porter and flotation tires or full walking beams front and rear. machines with 66/44-2 tires don't make too much mess if you refrain from using the same track too often... TJ 230A and 610's are good machines along with various others. I wouldn't waste my time in the woods with an old Pettibone or any other type of wheeled loader. The right gear will not cost you any more money.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
