Tractor Talk Discussion Board |
Re: old R model Mack
[ View Follow Ups ] [ Post Followup ] [ Return to Tractor Talk Discussion Board ]
Posted by Bill From Ontario on January 17, 2000 at 14:14:06 from (206.172.238.91):
In Reply to: old R model Mack posted by Tom S. on January 17, 2000 at 12:09:14:
When you consider that at one time there were more R model Macks on the road than any other truck, combined with the fact that most Macks outlive their owners, $650 is quite a deal. Getting one road worthy after sitting is quite another, I've seen guys dump $15000 on a yearly safety. Then there is the insurance, and cdl, fuel tax. The last few years it's been easier to lease trucks for harvest, than go through the yearly safety inspection BS. That and when the DOT sees a farm truck on the highway, it's like driving around with a big target on the door. Enough of the negative stuff. One of the easiest trucks to drive ( that I've driven) was a single axle R. It had the Mack 300hp Econodyne and a 10 speed, it's almost scary how you can lug a Mack. With the single axle, pulling and backing a 48' trailer was a snap in tight areas. I say go for it! You'll out pull any powerchoke.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|