Posted by 135 Fan on April 13, 2008 at 16:02:07 from (68.149.51.25):
In Reply to: Flail Mower Question posted by 37chief on April 13, 2008 at 12:15:06:
Don't let the pto drop below 540 rpm and you'll be fine as long as you have enough HP to run it and the knives are somewhat decent. If your cutting really tall grass and weeds and you don't have the power, it will rip the grass out and it will wrap aroung the cutter shaft. In real tall grass if you're low on power, you can lift it up a bit and go over a second time with it lower. If you run into barbed wire is a real pain to remove. BTDT. Flails are good if any garbage or rocks are hidden in the grass. What make of flail is it? Dave
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Machine Shops - by Curtis Von Fange. It is a story that repeats itself countless times. In the process of rebuilding a particular section of the tractor there is a broken part for which a replacement cannot be found. The parts houses find in their catalogue that it is unavailable. The dealerships call it a discontinued part. Salvage yards define it as hard to find or, even worse, rare. Everyone on the NET says, 'what is it?' But don�t despair there is another avenue that can be used to get that piece repaired. The local mach
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
