Posted by KRUSS1 on April 07, 2008 at 14:41:05 from (208.114.174.29):
In Reply to: Re: Tire Question posted by Allan In NE on April 07, 2008 at 13:46:12:
I think your question has already been answered,but I have run radials as low as 7 lbs. It depends a bit on axle weight. I have worried about spinning them on the rims, but have never had it happen. So, yep just even them up by eye.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Grain Threshing in the Early 40's - by Pat Browning. The setting is rural Wisconsin, halfway between East Troy and Elkhorn, on Hodunk Road, our nation was at war, and I was 6, 7 and 8 years old. George was our "threshing neighbor." He was the one with the threshing machine, a JI Case on steel wheels, and he pulled it to our farm with a JI Case standard tractor also on steel. In those days, steel wheeled implements were common. The roads were general gravel, so the lugs cutting into them wasn't a problem. George would set up the thresher, s
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
