Posted by Dick L on April 05, 2008 at 09:48:23 from (76.76.33.112):
I installed the new valve guides this forenoon. the head had the heavy brass core plugs which I thought would be fine. While heating the head to install the guides I found pin holes in two so I removed all of them. The delivered the guides and exhaust seats but not the intake seats. After measuring the seats I found that this head was not a candidate for over sized valves. When I first started to check this head out before milling the head and opening up the ports I had cleaned up the rust pits in the seats. This removed enough material that I would have to open up the firing chamber to fit over sized seats in. In doing that it would take counter measures to the sleeves and gasket which would take this project out of average pocket book range. Standard valves along with what I milled off the head will make it bark a little louder than the average B.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Operator Safety - Loader & Backhoe Operation - by Staff. Loader Operation Do not transport anyone in the loader bucket. Always carry the loader bucket low for maximum stability and visibility, whether the bucket is loaded or empty. Always use the recommended amount of counterweihting to ensure good stability. Be careful when handling large objects such as round bales, logs,
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
