Posted by rrlund on April 04, 2008 at 07:07:20 from (216.46.211.148):
In Reply to: OT politics and BS posted by riverbend on April 03, 2008 at 18:59:06:
Wait a minute. You post an OT to complain about OT? I don't stay on here very long if there aren't many good OTs going on. Yes,I farm,I work on tractors,I collect tractors,I belong to tractor collector clubs,I give advice on fixing tractors when I can. But there's more to life than tractors. As long as everybody's being polite and actually making sense with something to say,especially older folks who have lived different experiences,it's quite an education. Did you read the one a few weeks ago about the guy in the wheelchair who tried to give advice to a construction foreman on freeing a stuck dozer? The foreman dismissed him. Probably BECAUSE he was old and in a wheelchair. Turns out the old guy knew what he was doing and they had it out in SECONDS. If you don't like the OTs,aren't curious,think you know everything there is to know about life,skip over them,PERIOD. Let others use the internet as a social thing and move on.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
