Posted by Bob on March 26, 2008 at 13:25:59 from (69.178.228.68):
In Reply to: Re: Ford 8n posted by bullet on March 26, 2008 at 12:47:10:
DO NOT run the poor thing anymore without oil pressure!
ASSUMING there's oil in the crankcase, the oil pump may simply have lost it's prime, or it may have failed, OR the oil pickup tube MAY be cracked or broken off completely.
SADLY, the rod and main bearing are probably "toast" from lack of lube, and MAY have "spun". (Since you say it locks up.)
If a rod bearing(s) has spun, grinding the crank and replacing or reconditioning the rod(s) involved isn't TOO big of a deal. HOWEVER, if a main bearing has spun, the block may by RUINED, or at the very least need to be "line bored".
I don't know WHAT to tell you... if it's worth trying to prime the oil pump, and starting it again, or if that will just add mure runtime without oil, and cause even MORE damage.
I am making kind of a "drive-by" posting here, as I need to get back on the road. Surf over to the "N" Board, and post there, and/or search the archives there for HUNDREDS of postings telling how to prime the oil pump by removing the oil pressure regulating valve plug, the spring, and the valve, then squirting oil in the opening, which will drain down and prime the pump.
Also, you can remove the big engine oil drain plug and screen, then, looking up into the opening, the bottom end of the oil pickup tube should be dangling over the center of the hole. If you can get a finger up there, the tube should be reasonable solid, if the other end is still soldered tight to the oil pump.
GOOD LUCK... I'll check back later to see what you found out!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
