Posted by JMS/.MN on March 24, 2008 at 17:16:34 from (209.237.107.155):
In Reply to: Calling Dave from MN posted by in-too-deep on March 24, 2008 at 11:34:20:
When you get to SE MN, for example on I90 at Winona?, you can take a very scenic route on 61, along the Mississippi River. If you go as far as Hastings, and take MN 55, (does go through Metro), go to Kimball, and take MN 15 north to St. Cloud. At Kimball, you are nine miles from where I live. Or when you get to SE MN, many other routes to get to MN 15, staying south of Metro. Head for New Ulm or Mankato, both very scenic towns, good roads going up to Hutchinson, then Kimball, St. Cloud, etc. North of STC, follow 15 to Little Falls, head NW on 10 to Motley, North on 64 to the Bemidji area, or farther west on 10 to US 71, north to Bemidji area. Southern MN is largely German heritage, Metro is Scandinavian, NE- Iron Range, is Finnish and Italian. Along 71, New York Mills area, is Finnish. Many ethnic shops, restaurants, etc. in each of these areas.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
