Posted by Mike (WA) on March 19, 2008 at 15:59:09 from (69.10.197.246):
In Reply to: Need A Plow? posted by Allan In NE on March 19, 2008 at 12:28:22:
Rollover (two way) plows got their start in "rill" or "flood" irrigated areas. Don't know if any of you in the midwest are familiar with this, but in the Columbia Basin of eastern Washington, irrigation is from canals that follow the contour of the land, and with small pipes called "siphons", you drew water out of the canal and sent it downslope in the fields- either just over the field ("flood") or into grooves put into the field for rowcrops ("rills"). When you've got water trying to find its way downslope, a dead furrow isn't just an inconvenience, its a deal-breaker. Hence, the two way plow. Guys soon found out that even if you didn't have the irrigation imperative, it was just plain easier to start at one side of the field, and work across it, rather than laying out "lands" and such. I like the look of the plow in the picture, but would have to do some research to determine whether my Farmall C would pull it. LOL.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
