I have a high efficiency airtight fireplace insert with a couple of oversize computer fans to push more air around the insert"s heat exchanger, with less noise. Being located in the basement convection up & down the two stairways heats the bulk of the house. I also extended the cold air return plenum to draw from the ceiling infront of the insert. And just leave the fan running to circulate warm air to the farthest rooms. If doing the job again from scratch. To avoid smoke, dirt, bugs, dirty floors and for increased fire safety. The system will be similar to jdemaris"s. In all likelyhood the next heating system will be ground source water geo-furnace. And keep the forced air electric/wood insert for backup heat. My parent"s and Brother all wish they had installed their systems years ago. Add a good sized windturbine and net metering. Heat,cooling & power for "free". A little more freedom from external sour$es of heat/power.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Looking for a minneapolis moline zts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
