Posted by VaTom on March 11, 2008 at 09:25:09 from (216.12.124.38):
In Reply to: Re: O/T new well posted by T_Bone on March 11, 2008 at 05:30:11:
T_Bone, that is a good system. I picked up a commercial one for our next place, with indoor pool. Recycled from when I filled in a pool. Traded an hour of tractor time for all the hardware, which included that filter and a pump, neither a year old.
I get 6-12 months out of a filter change on our water system. Minimal sediment, more of a nusuiance. Just this morning was watering my greens, with filtered water. LOL
Bentonite is also my choice for foundation waterproofing on traditional construction. Different form for sealing casing, which is about the size of a marble. The advantage is that it soaks up water and expands, drys out and shrinks, ready to go again. The expansion plugs the water path.
Just a natural clay, already pretty old. In some areas (Denver), responsible for destroying foundations. Interesting stuff.
Concrete cracks, and stays cracked. Whole lot better than nothing for well sealing, but our state health dept. has found bentonite superior. Real simple to install. Foolproof- I used it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.