NE IA said: (quoted from post at 12:25:09 03/09/08) In a local church they have a 80 gallon electric water heater. It can not begin to keep up when they are hosting fund raiser suppers.
My question is this. Why can't we wire it so instead of the top element satisfying its needs first then the lower unit kicking in. I'm thinking kick both elemets in as soon as the top one demands heat. We could also set it very hot and use less, but it seems like other than wirring it should work. Will the top thermostat handle a double load if fused up or something on that order? I have no idea of the wattage of the elements, nor the brand name. It is my guess less than five years old considering the copper pipe connections.
Thanks in advance.
YOU DO NOT NEED TO DO THAT! Think about it if something happens to or even close to that riged-up heater guess what the outcome is gona be when the insurance get ahold of it. aint noway i would take that on. there are heater models that are wired from the factory to run two elements at once
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
