Posted by Erik MN on March 08, 2008 at 15:36:16 from (66.41.99.220):
In Reply to: Re: CHEATING IN SCHOOL posted by Walt davies on March 08, 2008 at 12:00:36:
Hello Walt, As a new industrial technology teacher, I feel as though I need to respond to your post as I am sure you would if someone told you that everyone in your profession was failing at what they do and they should all be fired. First of all, I also agree there is a long ways to go before we can be satisfied with the level of education of some students upon leaving school. I also agree that there are many students that have education levels far surpassing previous generations with new options right in the middle/high school (college in school, PSEO, Project Lead The Way, etc.) While I agree completely with the basic math facts idea, they DO need to know them (it is amazing how many students can not read a ruler), there are also many other factors today that were not so in earlier times. However, there are a lot of other factors in todays education system that were not in place in the 40s. We have NCLB being pushed so hard on the whole system that it is almost impossible not to teach to the federal tests without funding the special programs that are also "federally" required. It is not our choice to teach or not teach certain items / programs. In terms of cheating, the students knew if they got in trouble in school, they would be more afraid of what would happen when they got home (like myself - even though I am only 24). Now, if you so much as look at a student wrong let alone accuse them of something such as cheating, we are now the ones that have to deal with the wrath of the parents (which I am not afraid to do). Anyway, lets just think twice before we throw out the whole system. We are doing good things trying to get the students ready for work/college/whatever they choose is the best choice for them, yet there is still a ways to go. If we are ever satisfied, we are not doing our job (in my opinion).
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
