Posted by farmer boy on March 05, 2008 at 08:56:17 from (206.130.211.29):
In Reply to: Turning tractor over posted by Raleigh on March 05, 2008 at 07:27:06:
It happened a few years ago. We have a big bank barn with a good size barn yard. There were (are) blocks about 2"x2"x4" along the barn yard that make up the one wall. The blocks are two high(4" total height) and stockers love jumping these when your chasing them into a pen. We had some old silage wagons that we havn"t used in years and decided to put these at the top of the wall so the calves couldn"t jump. It wasn"t me backing up but I guess he was too concentrated on backing up straight and not paying attention to the front wheel. He felt it start to tip so he put it in neutral and jumped. Nobody got hurt but he must of been pretty shaken up.If the loader wouldn"t have been up so high we might have been able to save it by dropping the loader and holding the tractor stable. The stupid thing was that we got a loaner tractor while the tractor was getting the rear wheel fixed (bent disc)and the first thing he did was finish backing up the wagons.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
