Posted by Jon Hagen on March 03, 2008 at 16:21:05 from (12.175.230.37):
In Reply to: wheatland models posted by utupuller on March 03, 2008 at 15:06:47:
In the high desert, prairie pothole region of ND, the wheatland tractor was the norm and the row crop was the rare oddball, except for the red river valley area. Most wheatland tractors are low to the ground, with a low, non adjustable wide front axle, rear tred is non adjustable, and rear fenders are wide with nearly the top 180 degrees of the wheel covered to block dust and dirt. The draw bars are usually the wide swing roller variety, with a 3 pt being very rare. Mounted or semi mounted impliments were never popular here except for the little AC tractors.
When row crops like sunflower became popular in the 70's, many fabrication shops did a good business making add on 3 pt hitches and the machinery jockeys imported semi loads of used row crop tractors from the row crop states. Now with the roundup ready row crops, no one cultivates, so row crop tractors are again not much in demand.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.