Posted by Farmer Alf on February 24, 2008 at 21:29:27 from (66.225.189.20):
In Reply to: Engine knock? posted by swanny on February 24, 2008 at 10:51:50:
Hi Swanny,
An aftermarket oil pressure gauge costs about $20. This will give ya a hint at the bearing conditions without spending a lot of time or money.
Secondly my 3000 develops a tick/knock when the valves need adjusted. May not be your problem but again not much time or money involved to check.
These three cylinder Fords do have a rather unique sound. Find a neighbour with one and give a listen or go to the local dealer, pretend yer interested in a used 3 cylinder Ford and hit the throttle a few times during yer test run. If it sounds the same as yours chances are they are both fine.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Tinker�s Guide to Manifold Repairs - by Curtis Von Fange. A common characteristic of keeping older equipment is that some parts to make repairs can be extremely difficult to locate. For example, finding a replacement for a cracked intake or exhaust manifold on a unique tractor or odd brand can be a frustrating and downright impossible mission. So, what is an alternative solution to scraping out that �one of a kind� piece of history? First, decide if you are one to try a repair yourself or have someone else do it. If you are uncomfortable about
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
