Posted by Bruce Hopf on February 24, 2008 at 11:57:32 from (216.46.133.10):
In Reply to: Dont do this posted by John Spinney on February 24, 2008 at 10:38:21:
John Easy fix. Get a new bolt from hardwar store. Place bolt in drill press vise, standing up. Drill down the depth of the old one, lay on side, then drill the other hole through bolt. I do this all the time whenever I break bolts like this. Spend $1.00 to $2.00 for bolt. Drill bit if you don't have $1.00 to $4.00 depending on type or grade of bit. Or spend $10.00 to $40.00 at the dealer. Have no idea what dealer will charge, but cost more to by than to make yourself. Hope fhis helps. Will be as good as new form the dealer. P.S. Get the same grade of bolt as your old one.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
