jose bagge said: (quoted from post at 06:21:29 02/18/08) Getting old and eyes are poor, plus I like light- so last year I put a dozen 8" dual bulb light fixtures in the barn, all bought from home crapshot.
one by one, these suckers have died off- ballast is more than the damn fixture...this morning I flip the swith and i'll de damned if i only have one fixture in the whole place working. It's a damned shame when the bulbs outlast the fixtures!
I've been replacing 'em one by one with regular boxes, ceramic screw in fixtures and screw in flourescent- and chalking it up as an expensive lesson learned. I HATE WORKING IN THE DARK!!!!!
I hear you, Jose! I finally put those patio-type fixtures with motion-sensors in my barn. I've got 60w incandescent bulbs in them as they only come on in low light when somebody walks in. I don't spend a lot of time out there at night so they only run 10 min. or so when I feed after dark or before sunup. I've got them on the outside of the stalls so the horses don't trigger them when they're inside. They come on as soon as I go in and shut themselves off after I've gone back up to the house. I've got four in the barn and only one has crapped out in the last 5 or 6 years. The funny thing is that the cheapies that I bought at Wally World are still going; the one that was pretty spendy at ACE is the one that died after a year or so. :shock:
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.