Posted by Bob Huntress on February 13, 2008 at 21:27:44 from (65.4.218.195):
In Reply to: 1947 8n oil pressure posted by william Edester on February 13, 2008 at 20:04:44:
Oil pressure is used to give us an assurance that we are getting oil flow. The flow of oil is what actually is lubricating your engine. Because the tight spaces that oil must pass, there is an obvious resistance to flow, which is the oil pressure read by your oil pressure gage. As your engine wears over time, the spaces that the oil must pass become less tight, hence less oil pressure. Your oil pump, believe it or not, wears at a slower rate then your crankshaft bearing, for instance, therefore your flow may not have deminished nearly as much as your pressure. I mention this because you allude to the fact that you have been operating your tractor for sometime like this, without seizing your engine or throwing a rod, YET. Changing your oil to a 20w-50 may result in a minor increase in pressure, but it sounds like you're due for an engine overhaul. You may want to check your compression. Unlike when checking for a blown head gasket, you are looking for a consistantly lower compression across most of your cylinders. Also observe whether you have blueish smoke in the exhaust. Let me know what your compression test reveals.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.