Posted by Oldcraneguy on February 10, 2008 at 08:47:31 from (65.9.38.166):
In Reply to: Generator posted by newtothisgame on February 09, 2008 at 19:33:06:
What kind of operation you run is irrelevant. When sizing a generator whether for a farm or a nudie bar youve just got to look at the equipment you plan to use and find out what it draws. I usually total up all the 110v stuff (lights,small appliances,etc.)and convert it to watts (volts x amps= watts)then the same thing with the 220, total your watts and that gives you the # you need to run everything at once...It might be the case that its not practical to buy a gen big enough to run everything at once so you might wanna just figure out what items you MUST run at the same time. When figuring things like air-cond, water pumps, or pumps of any kind make sure you check the Starting Amps when doing your load calc. as that # will be much higher than Running Amps. (theres no law that says you have to start these at the same time)..Also make sure your 110v load is balanced between your 2 hot legs. Do you have a good Idea what kind of equipment you'll be powering? and what it draws? Also try to keep in mind future needs and balance it all out with you wallet/wife (the only hard part of the whole thing)...Good Luck...Don
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Farmall Story - by Ed Meadors. The year was 1978. Our young family had recently moved to rural Chesapeake, Virginia to a plot of land which would finally allow us to realize our dreams of a huge garden, critters and more lawn and pasture than we would ever use! We needed a TRACTOR; not a riding mower or tractor wannabe, but a real TRACTOR. The answer to our needs materialized in the form of a '44 Farmall A, complete with cultivators, discs, single plow, a 5ft.Woods belly mower and one, mounted spare 9.00x24 rear wheel.
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
