The truth hurts don't it? I thought you were finished on this subject? Like most true craftsmen, when I do a job, I finish the job so it looks professional. I don't care if it's fixing a wheel barrow handle or welding a 50 ton vessel. Anyone can see from your picture the unfinished and rusty welding cart that looks like it was made from some of the last pieces of scrap on the planet. No wonder you took jabs at me for complimenting a novice welder. His welds looked better than yours and you're the one with over 50 years experience! The difference between just a welder and a true craftsman is that the craftsman will always take the time to do a professional looking job. I never compromise quality just to get a job done. I take too much pride in my work, like any skilled tradesman would. If you're so sure of your skills as a welder, I'll over you a challenge. Start a new post with the same picture you posted and pole the people on this forum what they think of the quality and finish of your welding cart. Be sure to include the fact that you have been welding since 1954, have worked at many shops and even owned one and had formal training. After all, these are the facts aren't they? Also state that I think it's shoddy workmanship for a mega experienced welder. Let the people on here decide what kind of craftsman you are. If the majority thinks it looks professionally built. I will post that I don't have any clue what I'm talking about and won't offer any more advice on welding! What do you say? You could be rid of me? If I don't see a new post, I'll understand. You're too busy tarnishing your own brass! Maybe it would be better if I posted it to get the facts right? It's up to you. If you would have just politely disagreed with me without the comments, all this could have been avoided. I am done with this topic. I'm sure you'll read this though. Dave
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Tractor's Point of View - by John Manley. I began my life on August 3,1941. I was actually built at different times and days but I was officially an M Farmall on August 3.I was real nice and shiny. That�s me, in the old picture, third from the left. I was loaded on that train and sent to a little town in South Carolina. I didn�t get to see much of that town. I was moved off the train fast and on to the dealer�s
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
