I would like to ask several questions,I have A John Deere 250 amp stick welder.I typically use it in the DC arrangement,I get "bit" by a small screw on the stinger handle if I accidentally touch it while runnning a bead.unnit welds easier in Dc.It really "bites" if I plug into my AC side.I have a lever that pulls out on the upper left corner of control panel it pulls out at an angle and is a lock for the amp dial.If I try to change amps above 90 it is difficult to turn dial, and once there it will slowly work its way back down.I am not sure who made this for Deere but need a few parts for it that Deere no longer carries.Lastly I am "vertically challenged",I can run a beautiful bead when on a horizontal plane,but vertical I cant keep my hands steady.I have a medical implant that is connected to my spinal cord,it helps control my guts.I am not supposed to be around EMP's, I think this is what causes my tremors.I have tried starting from the bottom and the top but I cant seem to brace myself well enough to be steady.Thank you in advance
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Major Problems - by Anthony West. Following the aquisition of the two Fordsons to my collection I found that I was struggling to move them about. I had considered the possibility of driving the "F" to and from shows but anything other than local rallies was totaly impractical due to its sedate pace. I had also considered buying a landrover and trailer, but the price of a
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
