Michael, I used an Aluminum roof coating w/ fibers in the solution. This stuff is great! I covered two old barn roofs, Solid rust! no old glaivanized left on the roofs at all. Also numerous little pin holes up to half the size of a # 2 pensil. This stuff has to be brushed on. they looked like new roofs, still they do not leak, They are needing to be re coated now, just do not look bad enough to do it yet. OBTW....the roofs were done in 1995. The coating is jet black when you remove the lid. Then take electric drill and a stir rod to mix up the aluminum and fibers, then it takes on that aluminum color look. If your roof isn't too steep you can DIY! Only prep I did was use screws to secure any loose tin, No liquid primer or nothing. My place is in Central Texas, So the hot sun hasn't hurt it much, LOL! Hope this helps. Later, John A.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
