That ought to be a good idea, I'd imagine after getting a fire going I can check the temperature of the pipe, probably most concerned with the pipe from the stove to the wall, I reinstalled the old damper close to the stove, figuring if the pipe ever caught at least I can shut most of the oxygen down, damper on the stove door and the one on the pipe.
Obviously that would be a worst case scenario, I'll have to see how hot it gets wide open and choke it back a little if necessary. Right after the elbow above the stove to the horizontal to the wall, the pipe transitions from 6" to 7", so it's probably going to cool, then will cool further along the 4' it travels through the wall to the base of the chimney, so I'll have to monitor that area, when I initially cleaned the chimney and cleared the blockage from 25 + years on non use, those were the only areas with soot, mostly grinds, a few flakes. I made it easy to disassemble the pipe, no problem keeping an eye on things in there. Ive got a digital temperature reader for now, but see the magnetic wood stove thermometer listed and ones that look like you need to drill a hole in the stack to use.
I'll have to ask if his kids are on any of the teams, I think 1 or both played hoop, just approaching HS age now, nice area over there, I'm about 40 miles east.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
