Posted by Large-scale Iowan on January 22, 2008 at 05:08:47 from (75.104.160.58):
In Reply to: Cultivating Revisited posted by Allan In NE on January 21, 2008 at 21:31:25:
Was about the last to cultivate here--believed all the things about aeration, creating a dust mulch, growth spurt right after, etc. Finally gave it up do to inexperienced operators covering plants.Wasn't cultivating for weed control, as herb has them licked. We have done stand counts and standard deviation of spacing measurements for about a decade. When we stopped cultivating, our final stands improved, and our end rows began yielding nearly the same as the regular rows. With cultivation, the end rows always yielded at least 10% less. First pass in small corn was NEVER above 3 mph--took forever, caused soil erosion, cost thousands in labor, thousands in sweeps, plus combine and trucks had to bounce over ridges. My herb bill is over $50,000. Row-crop cultivators are worth scrap price here. I have a perfect 16 row that I gave over $13,000 for in my shed that needs to be cut up for scrap--I just can't make myself do it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
