Tractor Talk Discussion Board |
Re: One Ton Dually trucks.. How big A trailer can I get away with?
[ View Follow Ups ] [ Post Followup ] [ Return to Tractor Talk Discussion Board ]
Posted by Tim (UT) on December 20, 1999 at 10:54:01 from (151.155.25.229):
In Reply to: One Ton Dually trucks.. How big A trailer can I get away with? posted by Truck on December 19, 1999 at 16:49:20:
In most states, the limit will be what your tires can carry. In Utah (which uses the federal standards) a single tire, single axle is limited to 10,000 pounds and a dual tire, single axle is limited to 20,000 pounds - not to exceed the limit of the manufacturers rating on the axle or the tires. If you have some tractors, a farm to keep them on and a few animals, why not look at getting a farm license for a larger truck (like I did with my '62 Pete). I pay about half of what the yearly license would be in Utah (I pay about $250 a year) and can get farm insurance on it (and save a bundle as well). In most states (check yours out), you can only use the vehicle in conjuction with your farming operations, but purchasing and moving farm machinery is a part of that operation. In Utah, if you're using what would normally be a commercial truck for farm operations, you don't have to have a CDL, but you're limited to 150 miles away from your farm. Get a CDL, and you're covered anywhere in the 50 states. Also be aware that you're ARE subject to getting DOT inspections on your vehicle as well as paying any state road tax for states that you travel through. Typically, buying fuel in the states you're traveling through covers it - save those receipts. Tim (who LOVES his '62 Peterbilt with a 30 foot drop deck trailer that can haul anything (well, up to 64,000 GCVW)
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|