Posted by ChrisB on January 15, 2008 at 11:40:55 from (71.88.106.1):
In Reply to: shop compressor posted by George G on January 14, 2008 at 21:03:49:
guido said: (quoted from post at 14:30:44 01/15/08) HEY Ray
You said that the compressor on 240v will draw less current? Can you explain.
Guido.
While I am not Ray.....
and in the simplest way to explain.
current = amps
Double the voltage and the current (amps) will be half. Thus if a motor running at 120v and drawing 20 amps is converted to 230v then the amp draw will be 10amps.
Common thinking it is best to run a motor at a highest voltage allowed. Add to this the recent insane prices of copper cable. cheaper too as the cable rating (gauge) is determined by amp draw and not voltage.
Not that running 220v save on your electric bill as some think:
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
