Posted by another doug on January 03, 2008 at 04:38:12 from (4.224.222.198):
In Reply to: grain aeration posted by Dan-IA on January 02, 2008 at 16:57:32:
Dan, I am using only the fan portion of a cork screw aerator in a 12 foot hopper tank, the beans are nearly full, and that's going to be more screwing than this old man can handle,a pipe handle normally slides into holes on the air tube, then after the tube is down into the grain , you remove the pipe handle and throw it down to the ground trying not to injure your helper... it will not be reasonable to put this thing in that deep especially in the top hatch as close clearances while working there up on top of the bin roof and I don't want the fan assembly to stick outside in the weather or interfere with the hatch lid .... so I am just interested in the top portion, a small crust has formed as these bins have no eve vents or otherwise, I guess after the weather changed, some moisture collected in the top and could'nt escape,I did as you and ejected several buckets worth as best I could, yes a few "blue" beans still in there, some are a little "rubbery" , and some air up there will help, I don't think 14 percent moisture is bad, 15 would be ok, maybe but anything over.....no. The other guys said on this topic that these screw in aerators don't help much, they are right, but perfect for this situation, just don't try to think a guy can dry an entire bin using one of these things, maybe tractor supply has one, or check with an old farmer, I took one fan motor apart and oiled it last week, as it was sluggish when first plugged in.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Tractor's Point of View - by John Manley. I began my life on August 3,1941. I was actually built at different times and days but I was officially an M Farmall on August 3.I was real nice and shiny. That�s me, in the old picture, third from the left. I was loaded on that train and sent to a little town in South Carolina. I didn�t get to see much of that town. I was moved off the train fast and on to the dealer�s
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
