Posted by Spook on January 02, 2008 at 18:13:20 from (198.208.159.19):
In Reply to: Re: My Backround posted by Larry59 on January 02, 2008 at 09:37:03:
I am from SE Michigan, I ama 29+ year GM employee. I am a Tool & Diemaker by trade, but I have spent the last 29 years working on gages, primarily Zeiss CMM's. I changed my handle to Spook after going on midnight shift last year. I live in Howell, Michigan, have a little 10 acre spot. My wife has her own business, and we have 3 pygmy goats, a boxer dog, and some cats. I have 2 tractors, a Farmall H, and a 300 Utility. I play with tractors when I can, and I am looking forward to retirement from GM, hopefully I can indulge my hobbies some more. I am hoping to build my own shop in a year or so, a real "man cave" LOL!!! We hope you and your family had a good holiday and wish you and yours a healthy and properous new year.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.