Posted by BuzzyBee on December 28, 2007 at 20:15:10 from (71.204.122.141):
In Reply to: Re: new holland tc55 posted by Purple on December 15, 2007 at 17:43:44:
It sounds like the input shaft that splines into the clutch drive disc on the flywheel is damaged. This will cause the transmission to stop moving, the PTO to quit and the hydraulics to stop. The tractor has to be split in half at the engine to bell housing to fix.
Most TC55DA have hydraulic shift trans in them. Yours probably does as well.
One reason this happens is running a rotary cutter or some implement with a great deal of momentum to it. When you shut the PTO off, there is no over-running clutch in the trans. This causes a load on the powertrain, which snaps the input shaft off or damages the splines on it. An external over-running clutch on the PTO shaft will help.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Threshin Demonstration - by Michael Delaney. Introduction I bring you greetings from Prince Edward Island, Canada. We are Canada�s smallest province but big on farming. Maybe you�ve heard of us. Potatoes are our biggest crop. However, there is lots of mixed farming here also. I have a small mixed farm with 25-30 cattle. I make very good use of old machinery. I have a 135 MF Diesel, Farmall H and 1/3 share in an Allis B. I have complete lines of tillage and harvest equipment, and a saw gear etc. I have everything one would
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
