|
Tractor Talk Discussion Board |
Re: Whats your close call on a tractor?
[ View Follow Ups ] [ Post Followup ] [ Return to Tractor Talk Discussion Board ]
Posted by Charles on December 12, 1999 at 22:48:13 from (216.220.142.212):
In Reply to: Whats your close call on a tractor? posted by Highboyford on December 05, 1999 at 16:42:04:
I was using a small IH with a hay fork on the 3 pt. to carry logs and stumps to a big hole where I'd dump them. This hole was about 12ft deep and just to the side of a down hill road. The tractor doesn't have parking brakes so I'd park it cross-ways to the road with the fork full of logs hanging over the hole. I'd lower the lift and the logs would usually roll off. Well, they did'nt this time so I CAREFULLY balanced the tractor so I could shove a few off the back of the fork (don't tell me, I know). I could'nt kill the motor and put it in gear because the lift bleeds down too quick. So, as I am at the back of the fork jiggling a log the tractor starts to roll - backward into the hole. I jump up on top of her and grab the wheel just in time to accopany her rapidly and backwards to the bottom of the hole. The tractor "spears" itself to the bottom of the pit and I fly through the back of the seat breaking it out and knocking the wind out of me. I'm alive but the tractor is resting with the head up about 3/4 and with the hay fork stabbed deep into the sand. Cound'nt climb the wall going forward and could'nt back up further or release the fork. Had to dig "tracks" 3 ft down and several feet back so the tractor could roll back. Got rings of blue to purple to yellow bruises a square yard across my butt, legs and back from hit on the seat back. Still, I prefer this stupid experience to the cold chill of the safety police.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
