Posted by Bubby on December 18, 2007 at 17:53:06 from (69.77.207.81):
In Reply to: TRACTOR PRODUCTION #'s posted by POORDIRTFARMER on December 17, 2007 at 20:05:49:
The only ones I can relate to is the 2-135 and the 966/1066. I will never own another 2-135. You had to have a full can of ether to get it to start if it was below 40 degrees. We also had a lot of trouble with the steering box breaking. It is mounted under the radiator area on the front end. You had to be half monkey and half magician to get it out. The last one we took out is now hanging in a low spot on the fence. (heavy) It was somewhat awkward to shift, you just needed to have some patience. It did have good power and it would flat walk right through a loader if you werent careful. My 966 and 1066 IH are both Hydro. LOVE them. They make a great loader tractor because you can creep forward and back, no need to shift every time you stop. They also work great on a baler or bale processor. Mainly for the same reasons.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
