Tractor Talk Discussion Board |
Re: Whats your close call on a tractor?
[ View Follow Ups ] [ Post Followup ] [ Return to Tractor Talk Discussion Board ]
Posted by AH in Ark on December 09, 1999 at 13:42:56 from (204.180.108.81):
In Reply to: Whats your close call on a tractor? posted by Highboyford on December 05, 1999 at 16:42:04:
While returning a neighbors tractor and round bailer. A trip of about 5 miles with over a mile of that being down the side of the mountain which is about 10-15 degrees grade. Knowing the tractor did not have real good brakes I stopped at the top of the mountain and placed it into low gear and let the motor hold the tractor back. A little over half way down the mountain it kicked out of gear and from there on down things were a blur. Standing up on the brakes I managed to keep it slow enough to prevent a wild runaway but at about 100 yards from the bottom of the mountain is a right hand hairpin curve(Good for about 15 MPH in an auto). I had decided it was going to be a close call to make the curve or go straight ahead and through a pipe gate across the logging road. Didn't want to wreck the tractor but at last second decided to try and make curve. Swung out to left and hoped no oncoming auto traffic was anywhere near. Managed to get around curve on two wheels and the bailer up on one wheel. Got it back on right side of road and auto came up over little hill. I was then on straight away and just gentle slope but still runniing at about 20-30MPH and passed woman jogging and to this day she still didn't know how that tractor and bailer got by her so quick as all you could hear was the lug wheels humming on the pavement. O'yes the tractor died when it kicked out of gear. From then own when I helped neighbor move his tractor I kept one foot braced on the gear shift.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|