Posted by Fordfarmer on December 16, 2007 at 06:44:16 from (69.179.255.195):
In Reply to: Oil Filter - Ford 861 posted by Wade Erickson on December 16, 2007 at 05:52:21:
"the filter that sits below the cap" -- Do you mean the mesh filter under the breather cap (which is also where you add oil)? That one only needs to be cleaned. The oil filter on the left side of the block should be replaced at each oil change. Could be original style canister type, or often converted to spin-on. Spin-on is New Holland 300 Dual, Car Quest 51515, Fram PH8A, etc., not sure about the cartridge type. (although those are available at CarQuest or Napa,too.) Book calls for 10w in cold weather, 30w in warm weather, but that was printed before good multi-weight oil was available. I run 15w40 year-round in my tractors. (northern WI)
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
