I am building one right now from an old kelley incinerator. ITs about 4' diameter and 4' long inside and lined with refractory so its perfect to start with. There in a company out of montana that makes the seton boiler that I am tring to model it after cause the design looks good. I would buy it if I could afford it. I am using a water tube type heat exchanger and a heating the incoming combustion air after it exits the water heat exchanger. Then this is going to sit inside a 20' shipping container so I have dry wood storage and a place to house the burner and I don't have to stand out in the wind while I stoke it. I hope to eventually get to the point where once I load the wood by hand on a dump trailer I can handle it with the loader from there. Stacking wood is the pitts so I hope to simplify this.
I will have to let you know once I get it going how it works. Right now I hope to have it going in 2 weeks but I usually can take any timeline of mine and double it.
I burn wood cause its cheap and someone else is not getting rich from me getting warm.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
