Properly set up, all fuel gasses will do a very good job. Most people that do welding for a living and want to do the best quality work, the fastest, choose acetylene. Most welding trucks use acetylene as well. Although it can be used for welding, very little O/A welding is ever done. Owner/operators of welding trucks need to watch their expenses, especially concerning gasses, more than anyone and most still choose acetylene. I've worked in some really cheap shops that still used acetylene. I don't think there is as much of a savings as people think using propane. For cutting you never really need more than 5 PSI of acetylene. With propane you need a higher pressure which uses more fuel gas as well as oxygen. An acetylene cylinder typically lasts as long as 3 larger oxygen cylinders. Most shops are more concerned with the price of oxygen as they go through it a lot faster than acetylene. Propane uses more oxygen which diminshes savings even more. With a standard cutting torch, it would be extremely rare to withdraw acetone from the acetylene cylinder. For a lot of people propane is just more convenient and easier to get filled. People who use a torch a lot will have an extra cylinder available. Welding supplies will often loan or rent an extra cylinder for a short period, if you have a bigger job. When used properly acetylene is pretty safe. You rarely hear of accidents. Propane can be just as dangerous. If you get blown up, it doesn't make any difference what gas it was. Keep your equipment in good repair and you shouldn't have any problems if you follow proper operating procedures. Dave
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Trailering Your Tractor - by Curtis Von Fange. One of the fun things of summer and fall are the parades and tractor shows that go on across America. Many owners of tractors travel long distances to attend these shows and they usually take their restored iron along with them. Safe trailering practices and inspections will ensure that the event is a fun one. A good habit to develop when using a trailer is to give that �quick look over� before taking it on a trip. Before hooking up to it check the tongue for proper operation. The latche
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
