Tractor Talk Discussion Board |
Re: Clearing Brush
[ View Follow Ups ] [ Post Followup ] [ Return to Tractor Talk Discussion Board ]
Posted by Steve Hansen on December 07, 1999 at 17:50:09 from (208.21.138.162):
In Reply to: Clearing Brush posted by Ken on December 04, 1999 at 07:22:10:
Ken, Couple of things for you to keep in mind: Check with other vinters in your area and find out who they used to clear their land. Ask them how long it took, how much it cost, and assess their degree of satisfaction. Won't take you very long to identify the better operators and get some idea of the cost. The bigger machines usually costs more per hour but less for the job. With dozers, there is a break. If you use an operator who pulls his dozer behind a dump truck you are going to have to pay for a minimum number of hours - usually 3 or 4. If you hire an operator with a big dozer, one that must be transported on a special carrier, you may be required to pay a transport charge or a minimum of several days operation. So, in some cases, a smaller machine may take longer but cost less. Need to work all of the options out on paper. Keep your receipts. Land clearing is a capital improvement cost. While you are talking to other vinters get their recommendations on tractors, sizes, brand names, etc and buy one early. Cleared land does not stay cleared very long if left alone. To protect your clearing investment you need to get out on it right away. Steve
Follow Ups:
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|