Posted by Goose on December 06, 2007 at 08:05:57 from (199.184.119.22):
I would like to respond to today's feature article about removing dents from gas tanks.
I tried the exact same proceedure on a gas tank. The end result was I blew the tank into a flat piece of tin, I myself landed ten feet back inside my shop on the hood of a stock car, busted my torch, cut my leg, and fractured my thumb.
I had a large spool of solder sitting on the tank which I couldn't find after the blast. My wife swore something hit the house, about a hundred yards from my shop. A couple of years later when I happened to be on the roof of the house, I found the spool of solder in a rain gutter.
If anyone else wishes to win the annual Darwin Award, more power to them. I, personally, will not EVER, EVER, EVER again approach a gas tank with an open flame. I theorized after the fact that filling the tank with water with a small bubble at the area to be mended actually compresses gas fumes to cause an even larger explosion.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Revival of a John Deere Combine - by The Red, John Fritz. For several years I had been driving by a farm house on the west side of Indianapolis that had a John Deere combine parked in high weeds in a lot behind the house. The gentleman no longer farmed because the entire area was developed with housing and light industry. I had stopped several times and knocked on the door but no one would answer. My curiosity was up and I wanted to contact the owner. I wanted to see what he planned to do with the combine.
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
