Tractor Talk Discussion Board |
Re: Whats your close call on a tractor?
[ View Follow Ups ] [ Post Followup ] [ Return to Tractor Talk Discussion Board ]
Posted by Steve T on December 05, 1999 at 20:17:29 from (208.150.193.12):
In Reply to: Whats your close call on a tractor? posted by Highboyford on December 05, 1999 at 16:42:04:
I had an old narrow front JD "G" with a farmhand F-11 loader on it. I had an old pickup with out a rear end in it that I was moving out of the way. I had to go around a corner that was on a side hill, and was pulling it in reverse with the loader and a LONG chain. As I was going around the corner, the left rear wheel came off of the ground about 2 feet. Instinct told me to pull the clutch lever, but all that did was stop the wheel. I quickly dropped the bucket to let off the tension, and was able to save myself, and the tractor. Shortly afterward, I got rid of the tractor. Out of the three tractors that I now have, only one has a narrow front, and it is going to be restored for show only. No more narrow fronts for me. Steve T
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|