|
Tractor Talk Discussion Board |
Re: Whats your close call on a tractor?
[ View Follow Ups ] [ Post Followup ] [ Return to Tractor Talk Discussion Board ]
Posted by Mongo on December 05, 1999 at 17:25:23 from (205.152.158.253):
In Reply to: Whats your close call on a tractor? posted by Highboyford on December 05, 1999 at 16:42:04:
I started off with an Oliver Super 77 Diesel with a NF and bought a pull behind bush hog to mow off my farm I had just bought. We aren't too flat around my parts and my front field is sloped on three sides. It was the first time I was to mow it and wanted to get as much mowed off as I could. I was running along the slope dodge'n the cedars when I came across a place where they had plowed into a small bank leaving a ledge. As I went along in the tall grass and weeds, my nose gear passed just down hill of the ledge but the rear wheel started to climb the bank. As the tractor began to list, the clutch pedal was getting farther and farther away. I was leaning over the right fender with all I had and was ready to go when the uphill wheel started to get light and spin. I knew it was all over and was praying fervently when it started to creep back down the other side of the bank. I continued to mow that day, and it was several hours before I had a chance to change my underwear. The next day, I went out and bought a wide front end for the tractor.
Several lessons are to be had with this story. One is to walk unfamiliar ground before getting into a fix and another is the $500 I paid for the wide front end was the cheapest life insurance policy I ever bought.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Fabricating Sidesheets - by Chris Pratt. The easiest and best first-time project for wanna-be sheet-metal workers like myself is flat or nearly flat metal cut and drilled to be a tractor's sidesheet. A sidesheet is sheetmetal to cover either the engine as in the case of early Oliver's, Massey-Harris' and many crawlers or the wiring and electrical components as in the case of the Massey-Harris Pony, Allis Chalmers' D Series (D-14, D-15, D-12, D-10, D-17, and D-19). The need for fabricating becomes obvious when you go to buy any of these
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
